MacDon PW8 Pick-Up Header - Manual (Page 101)

MAINTENANCE AND SERVICING
4.5 Endshields
The endshields are molded polyethylene covers that are attached to the ends of the header. They mainly provide
shielding for the header drive components and also display the make of the combine. The left endshield is hinged
to the endsheet, and can be opened for routine maintenance or easily removed for major servicing. The right
endshield is bolted directly to the header.
4.5.1 Removing LH Endshield
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
1. Lower header to ground, shut down engine, and
remove key from ignition.
2. Unlock endshield (B) by turning latch (A)
counterclockwise until it stops (slightly more than
one-half turn) using a standard end screwdriver.
Figure 4.12: Endshield Closed
3. Open endshield (A) until support (B) can be moved into
lock position.
Figure 4.13: Endshield Open
169489
93
Revision A