MacDon PW8 Pick-Up Header - Manual (Page 119)

MAINTENANCE AND SERVICING
8. Loosen three bolts (A), and remove cover (B).
9. Pull hoses out of cover (B).
Figure 4.53
10. Pull hoses through hole (B) in endsheet, and from hole
in frame (A).
Figure 4.54
Installing Hydraulic Motor Hoses
1. Route the two longer hoses (A) and (B) through hole
(C) in endsheet and hole (D) in frame. Angled fitting
on hose (B) goes to the pick-up rear drive motor. Hose
(A) with yellow cable ties has identical fittings at both
ends, and attaches to forward drive motor at fitting with
yellow cable tie.
Figure 4.55
169489
111
Revision A