4replacing lamp housing, Replacing lamp housing, 4 replacing lamp housing – MacDon PW8 Pick-Up Header User Manual

Page 181

4.13.4

Replacing Lamp Housing

If light housing is cracked or broken, it should be replaced.

1. Lower header to the ground, shut off combine, and

remove key from ignition.

2. Pull wiring harness (A) out of lamp bracket, and locate

connectors inside the wiring harness.

3. Disconnect light wiring from harness.

4. Remove four nuts (B), and remove lamp (C) from

bracket.

5. Install new lamp (C) on bracket, and secure with four

nuts (B).

6. Connect lamp wiring to harness (A), and route wires

inside plastic covering. Seal with black tape.

7. Check wiring harness is not damaged, and secure

harness inside lamp bracket.

8. Check operation of new lamp.

Figure 4.192

169489

173

Revision A