3sealed bearing, Sealed bearing, 3 sealed bearing – MacDon PW8 Pick-Up Header User Manual

Page 100

4.4.3

Sealed Bearing

1. Clean shaft and coat with rust preventative.

2. Install flangette (A), bearing (B), second flangette (C)

and lock collar (D).

NOTE:

The locking cam is only on one side of the bearing.

3. Install (but do not tighten) the flangette bolts (E).

4. When the shaft is correctly located, lock the lock collar

with a punch.

NOTE: The collar should be locked in the same direction

the shaft rotates. Tighten the setscrew in the
collar.

5. Tighten the flangette bolts.

6. Loosen the flangette bolts on the mating bearing one

turn, and retighten.

This will allow the bearing to

line up.

Figure 4.11

169489

Revision A