MacDon PW8 Pick-Up Header - Manual (Page 56)

OPERATION
2. Slowly drive combine up to header until feeder house
saddle (A) is directly under the header top beam (B).
3. Raise feeder house to lift header, ensuring feeder
saddle (A) is properly engaged in header frame.
Figure 3.46: Header on Combine
4. Lift lever (A) on header at left side of feeder house and
push handle (B) on combine so that hooks (C) engage
pins (D) on both sides of the feeder house.
5. Push down on lever (A) so that slot in lever engages
handle to lock handle in place.
6. If locks (C) do not fully engage pins (D) on header,
loosen nut (E) and adjust position of pin (D) as
necessary (both sides). Tighten nut.
7. To obtain full lock on pin (D) when (B) and (A) are
engaged, loosen bolts (F), and adjust lock as required.
Retighten bolts.
Figure 3.47: Engaging Locks
169489
48
Revision A