MacDon PW8 Pick-Up Header - Manual (Page 152)

MAINTENANCE AND SERVICING
19. Install the lock collar (A) onto the bearing, and rotate it
counterclockwise until tight.
20. Start combine, and raise header fully. Shut down
combine, and remove key from ignition.
21. Remove wooden support.
22. Engage combine header lift cylinder safety props.
23. Tension the drapers. Refer to Section Adjusting Draper
Belt Tension on Rear Deck, page 69 .
Rear Deck - Idler Roller Bearings
Replacing Rear Deck Idler Roller Bearings
1. Open left endshield. Refer to 3.3.1 Opening LH
Endshield, page 25
2. Fully release draper belt tension. Refer to Section
Adjusting Draper Belt Tension on Rear Deck, page 69 .
169489
144
Revision A