MacDon PW8 Pick-Up Header - Manual (Page 72)

OPERATION
3. Check the pick-up height (A). If adjustment is required,
or if another distance is desired, proceed to next step.
4. Raise the header with the combine control to take the
load off the wheels.
Figure 3.79: Pick-Up Height
5. Loosen the two nuts (A) on wheel plate.
6. Position wheel plate cog to desired number on frame.
Number 2 position should provide 1.0 in. (25 mm)
clearance to ground.
7. Tighten nuts (A).
8. Repeat steps 5.–7. for the opposite side.
9. Adjust the AHC if necessary.
Figure 3.80: Pick-Up Height Adjustment
169489
64
Revision A