MacDon PW8 Pick-Up Header - Manual (Page 180)

MAINTENANCE AND SERVICING
4.13.2 Replacing Transport Light Bulb
The transport lights are an important safety feature. Keep lights clean, and replace defective bulbs.
1. Lower header to the ground, shut off combine and
remove key from ignition.
2. Remove two screws (A) with a Phillips screwdriver.
3. Pry off the lens (B).
4. Push in and turn bulb counterclockwise slightly.
Remove the bulb.
5. Place the new bulb in the socket, push in and turn
clockwise until it stops.
6. Replace lens (B) and secure with two screws (A).
Figure 4.190
4.13.3 Replacing Lens
1. Lower header to the ground, shut off combine, and
remove key from ignition.
2. Remove two screws (A) with a Phillips screwdriver.
3. Pry off the lens (B).
4. Install new lens (B), and secure with two screws (A).
Figure 4.191
169489
172
Revision A