MacDon PW8 Pick-Up Header - Manual (Page 165)

MAINTENANCE AND SERVICING
8. Disconnect hydraulic hose (A) from cylinder. Install cap
onto hose end, or wrap with plastic.
Figure 4.161
Installing Slave Cylinder
1. If installing new slave cylinder:
a. Remove the 45 degree elbow (A) from old cylinder.
b. Remove plug from new cylinder port.
c. Install elbow (A) onto new cylinder as shown.
Ensure fitting is in line with cylinder, and tighten
jam nut on elbow.
Figure 4.162
2. Connect hose (A) from master cylinder to elbow (B).
Tighten fitting.
Figure 4.163
169489
157
Revision A