Lenze TCF Series - Manual (Page 46)

P12 TB-13C FUNCTION SELECT
This selects the function of terminal TB-13C . Closing TB-13C to TB-4 (or opening in the case
of setting 06) activates the selected function . The following functions can be selected:
01 NONE: Disables the TB-13C function .
02 0-10 VDC: Selects a 0-10 VDC signal (at TB-5) as the AUTO speed reference
input .
03 4-20 mA: Selects a 4-20 mA signal (at TB-25) as the AUTO speed reference
input .
04 PRESET SPEED #3: Selects PRESET SPEED #3 as the AUTO speed
reference . The drive will operate at frequency programmed in Parameter 33 .
05 INCREASE FREQUENCY: Increases the speed setpoint when using the MOP
function . Refer to Section 10 .6 .
06 EXTERNAL FAULT: Sets TB-13C as a normally closed external fault input . If
TB-13C is open with respect to TB-4, the drive will fault .
07 REMOTE KEYPAD: Selects the optional remote keypad as the control source .
Refer to Parameter 14 - CONTROL .
08 DB FAULT: Sets TB-13C as a dynamic braking fault input when using the
optional dynamic braking module . When this input is activated by the dynamic
braking module, the drive will trip into a "dF" fault and the motor will coast to a
stop . Refer to the manual included with the Dynamic Braking option .
09 JOG REVERSE: Jog in the reverse direction . In this mode, the drive will JOG
at the speed programmed into Parameter 34 - PRESET SPEED #4 . JOG is
not available in Vector Torque mode .
10 ACCEL/DECEL #2: Selects the acceleration and deceleration time
programmed into Parameter 42 - ACCEL/DECEL #2 .
WARNING!
When operating in JOG mode, the STOP terminal (TB-1), the AUXILIARY
STOP function (setting 07), and the STOP key on the optional remote keypad
WILL NOT stop the drive . To stop the drive, remove the JOG command .
JOG REVERSE will operate the drive in reverse rotation even if ROTATION
DIRECTION (Parameter 17) is set to FORWARD ONLY .
NOTE
If the drive is commanded to JOG REVERSE while running, the drive will
enter JOG mode and run at PRESET SPEED #4 . When the JOG command
is removed, the drive will STOP .
42