Lenze E84AVSCx 8400 StateLine C - Manual (Page 25)

Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
25
5 Before commissioning
5.5 Check software version (firmware version) | C00002/19
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00002/19
C00002/21
C00003
5.5 Check software version (firmware version)
Particularly with regard to the use of older controllers (e.g. if the customer is using one from stock)
it makes sense to check the software (firmware) version.
Reset error
Note: After the reset (acknowledgement) of the current error, further errors may be pending which must also be
reset.
• The current error is displayed in C00170.
Selection list (Lenze setting printed in bold) Info
0 Off / ready
1 On / start
Reset (acknowledge) current error
Delete logbook
Selection list
(Lenze setting printed in bold) Info
0 Off / ready
1 On / start
Delete all entries in the logbook of the controller
Status of the last device command
Status of the device command executed last (C00002).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
The software version of the controller can be seen on the
nameplate in the "HW/SW" line and can be determined by
reading out code C00099.
Firmware version
C00099
06.00.00.00