Lenze E84AVSCx 8400 StateLine C - Manual (Page 10)

3 Overview of terminals
10
Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Control terminals
X1 CANopen connection
S1 CANopen settings
(Bus terminating resistor, baud rate and node
address)
X3 • Analog inputs/outputs
• 10 V reference voltage
Note: Voltage input A1U and current input A1I
must not be used simultaneously!
X4 • Digital inputs/outputs
(according to IEC 61131-2, type 1)
• External 24 V supply voltage
(for control electronics)
• 24 V voltage output
X6 Diagnostic interface (DIAG)
• For keypad ( 14) or PC connection ( 18)
MMI Slot for memory module ( 19)
• MMI = abbreviation for "Memory Module
Interface"
LED Status displays of the device status ( 44)
Description of the warning signs 
 Long discharge time!
All power terminals remain live for some minutes after mains disconnection!
The time is given below the warning symbol on the device.
 High leakage current!
Carry out fixed installation and PE connection in accordance with EN 61800-5-1!
 Electrostatic sensitive devices!
Before working on the device, the staff must ensure to be free of electrostatic charge!
 Hot surface!
Risk of burns!
Hot surfaces should not be touched without wearing protective gloves.
'595'<
&$1581
'59(55
&$1(55