Lenze E84AVSCx 8400 StateLine C - Manual (Page 12)

5 Before commissioning
5.1 Selection of the appropriate commissioning tool
12
Lenze · 8400 StateLine · Operating instructions · from Firmware V06.00 · DMS 1.2 EN · 12/2012 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5 Before commissioning
Being a component of a machine which includes a speed-variable drive system, the controller needs
to be adjusted to its drive task. The controller is adjusted by changing parameters which are saved
in the memory module. The parameters can be accessed by keypad, by the »EASY Starter« or by the
»Engineer«. Access is also possible by a master control via fieldbus communication, e.g. via CAN bus.
5.1 Selection of the appropriate commissioning tool
There are several possibilities for commissioning the 8400 StateLine controller:

Danger!
In general, changing a parameter causes an immediate response in the controller!
This may lead to undesirable behaviour on the motor shaft if the controller has been
enabled! Setpoint sources, for instance, may switch over all of a sudden (e.g. when
configuring the signal source for the main setpoint).
Certain device commands or settings which may cause critical states of drive behaviour
constitute exceptions. Such parameter changes are only possible if the controller is
inhibited. Otherwise, a corresponding error message will be issued.
Commissioning with keypad X400 (diagnosis terminal X400)
The keypad is an alternative to the PC for the local operation, parameterisation, and diagnostics in
a simple manner. The keypad is especially suitable for test or demonstration purposes and if only a
few parameters have to be adapted.
Commissioning with PC and »EASY Starter«
The »EASY Starter« is a Lenze tool for easy online diagnostics, parameter setting and
commissioning of the controller.
Commissioning with PC and »Engineer«
The »Engineer« is a Lenze engineering software for parameter setting across all devices,
configuring and diagnosing individual components (as for instance controllers, industrial PCs,
motors, I/O systems) and machine control systems.