Landoll 2131 Wing Coulter Chisel - Manual (Page 44)

3-8 F-721-0513 Edition
ASSEMBLY INSTRUCTIONS
Center Frame Tires
1. Install the tire and wheel assemblies on the center
section (See Figure 3-4.)
2. All models use tire and wheel assembly (p/n 157000
- Galaxy or p/n 165235 - Goodyear or p/n 175830 -
Carlisle). (See Figure 3-5.)
Figure 3-5: Tire Placement
Fold Anchor And Bolt-on Mount
Installation
1. For 17 and 19 shank models, assemble the fold
anchor to the rear cross bar using u-bolts and 5/8-11
hex lock nuts (See Figure 3-4.) Position fold anchor
so that the hose loops point toward the front of the
machine.
2. For 21 - 25 shank models, assemble two fold
anchors to the center frame cross bars using u-bolts
and 5/8-11 hex lock nuts (See Figure 3-4.) Position
fold anchors so that the hose loops point in toward
each other. The hose loop on the front fold anchor
should face to the rear and the hose loop on the rear
fold anchor should face to the front.
3. Attach base end of 4 x 30 hydraulic cylinders to both
sides of fold anchor(s) using fold pin and 5/16 x 2-1/2
spring slotted pins. The front fold cylinder fittings
should face the rear of the machine. The rear fold
cylinder fittings should face the front of the machine.
4. On the 2131-21, 2131-23, and 2131-25 models,
attach the bolt-on hinges to the right and left sides of
the center frame using 3/4-10 x 6-1/2 hex head cap
screws, hinge base plate, and 3/4-10 hex lock nuts
(See Figure 3-4.)
IMPORTANT
Do not tighten bolt-on hinges until wings are
installed.
NOTE: ALL TIRE/WHEEL ASSEMBLIES ARE
MOUNTED WITH THE VALVE STEM FACING
OUTWARD.
2130 tire placement
VALVE STEM