Landoll M-88 TRANSPORT LINK - Manual

INSTALLATION INSTRUCTIONS
FOR
BRILLION M-88 TRANSPORT LINK
FIGURE 1 FIGURE 2
With your transport link it, you will receive a 3/8” X 3” long capscrew
with two 3/8” nuts. Put this capscrew through the hole in the left hand
center truss near the cross strap which holds the two trusses together.
When your machine is in working position, store your transport link by
placing one strap on each side of the capscrew. This will keep it out of
the way and prevent it from striking the cylinder arm when the machine
Always remove this link before retracting the cylinder to prevent
If your machine does not have a hole in the right place, drill a 7/16 dia.
hole as shown in Figure 1.
See Figures 1 and 2.
is lowered or raised.
damage.
0613 4J638
8”
1 1/8”
7/16” Dia