Landoll 1P153 - Electric Clutch Kit for Seeders - Manual

506
1P153
1P153 - Electric Clutch Kit for Seeders
1/8” GAP
1. Check that clutch case has proper
clearance between rubber bumper stop.
Improper clearance may prevent the clutch from
engaging or cause it to disengage.
3. Route wire along frame and drawbar. Secure to frame and drawbar or with
hydraulic hoses and warning light harness by cable ties or adhesive mounts.
2. Connect clutch wiring harness
to clutch lead.
4. Install switch on tractor in a convenient location with the velcro included or other type of mount
(not included).
5. Attach wire lead to power source and secure wire.
6. Check clutch operation. Clutch will disengage when power is applied. (Clutch will make a clicking
sound). Set seeder on the ground and drive a short distance whole turning switch on and off.
The seed cup shaft will stop rotating when switch is turned to “OFF” position.
7. Turn switch to “ON” position when seeder is not used to shut off power to prevent possible over-
heating of clutch coil.
Clearance from
Bumper Stop
Clutch Lead
Clutch
Clutch Wiring Harness
Clutch
Bumper Bolt
Adhesive Mount
Clutch Wiring
Harness
Warning Light Harness
Hoses &
Hose Clamps
Cable tie
Note: Chain included in box assembly for conversion only. It is not used
with factory assembled transmissions.