Landoll 3K997 AUXILIARY CYLINDER KNIT - Manual

3K997 AUXILIARY CYLINDER KNIT
(See reverse Side for Kit # 4K789)
DISCONNECT HOSE FROM ROD
END OF 9D524 CYLINDER (LEFT
SIDE OF MACHINE) AND REROUTE
TO THIS PORT. ASSEMBLE 8J651
BREATHER HERE.
3K995 CYLINDER
BRACKET
3/4” U-BOLTS
REAR FRAME TUBE
OF PULVIMULCHER
ASSEMBLY INSTRUCTIONS
The 3K997 Auxiliary Cylinder Kit adds a third hydraulic cylinder to the rockshaft of WL Model Folding Pluvimulchers.
To install the kit, position the 3K995 cylinder bracket on the top of the rear frame tube. Line up the cylinder bracket
with the middle rockshaft arm and attach with 3/4” U-bolts, lockwashers, and nuts. Remove pin and
spacer washers from the rockshaft arm. Discard the spacer washers and reassemble with the rod end of
the cylinder attached as shown above. Attach the base end of the cylinder to 3K995 cylinder bracket.
Disconnect the hose from the rod end of the 9D524 cylinder on the left side of the machine. Reroute this hose end to
the rod end of the middle cylinder you’ve just installed. Install 8J651 breather into the rod end port of the left
cylinder and also into the bast end port of the middle cylinder as shown above.
It is shown above, assembled to the middle rockshaft arm.
0613 3K998