Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 7)

1K705 Page 5
S afety S igns
S afety S igns
There are three levels of hazard intensity that ap-
pear with the safety alert symbol on safety decals:
DANGER, WARNING, and CAUTION. The level
of hazard intensity is determined by the following
defnitions:
DANGER - Immediate hazards which
WILL result in death or serious
personal injury.
WARNING - Hazards or unsafe practices
which COULD result in death or
serious personal injury.
CAUTION - Indicates potentially hazardous
situations, or directs attention to
unsafe practices which could
result in minor or moderate injury.
• Examine safety decals and be sure you
have the correct safety decals for the
machine.
• Order replacement decals through your
BRILLION dealer.
• Keep these signs clean so they can be
observed readily. It is important to keep
these decals cleaned more frequently
than the machine. Wash with soap and
water or cleaning solution as required.
• Replace decals that become damaged or
lost. Also be sure that any new machine
components installed during repair
include decals which are assigned to
them by the manufacturer.
• When applying decals to the machine,
be sure to clean the surface to remove
any dirt or residue. Where possible, sign
placement should protect the sign from
abrasion, damage, or obstruction from
mud, dirty oil, etc.
• Decals for the Extended Frame Soil Builder
are pictured below. Their locations on the
machine are shown on the next page.
1. 8J310 .... Decal, Caution List
2. 3J706 .... Decal, Warning-Hydraulic Leaks
3. 528933 .... Decal,Reflective Red
4. 528934 .... Decal, Ref lective Amber
5. 528938 ... Decal, Reflective Red-Orange
1
2
3
4
5
WARNING
791rev5-30-05
WARNING
DO NOT GO NEAR LEAKS
High pressure oil easily punctures
skin causing serious injury,
gangrene or death.
If injured, seek emergency medical
help. Immediate surgery is
required to remove oil.
Do not use fingers or skin to
check for leaks.
Lower load or relieve hydraulic
pressure before loosening fittings.
CAUTION
1. DO NOT LUBRICATE, ADJUST OR REPAIR WHEN MACHINE IS IN MOTION.
2. DO NOT TOW OR TRANSPORT FASTER THAN 15 MILES PER HOUR.
3. DO NOT RIDE OR ALLOW OTHERS TO RIDE ON THE MACHINE.
4. BLOCK UP ALL HYDRAULICALLY OR MECHANICALLY RAISED COMPONENTS TO PREVENT
UNINTENDED LOWERING OR LOWER THE MACHINE TO THE GROUND TO MAKE ADJUSTMENT
OR REPAIRS OR WHEN NOT IN USE.
5. KEEP ALL PERSONS AWAY FROM MACHINE DURING HITCHING AND OPERATING.
6. SLOW DOWN BEFORE MAKING SHARP TURNS OR USING THE BRAKE.
DRIVE SLOWLY OVER ROUGH GROUND, SIDE HILLS, AND AROUND CURVES TO AVOID TIPPING.
7. COMPLY WITH ALL LAWS WHEN TRANSPORTING THE MACHINE ON PUBLIC ROADWAYS.
8. INSTRUCT ALL OPERATORS IN THE SAFE OPERATION OF THE MACHINE.
REVIEW THE OPERATOR’S MANUAL FOR CORRECT PROCEDURES.
9. BLOCK IMPLEMENT TO PREVENT MOVEMENT WHEN UNHITCHED FROM TRACTOR.
10. KEEP ALL GUARDS AND SHIELDS IN PLACE WHILE MACHINE OR PARTS ARE IN MOTION.
8J310
6. 2P151.......SMV Sign
6