Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 28)

1K705 Page 26 791rev5-30-05
• Attach the hitch to the front of the drawbar with a
1-1/4 x 8-3/4 pin, flat washers and 5/16 x 2 roll pins.
• Attach the drawbar jack by slipping one tube
over the other and inserting the pin.
--When the machine is parked use the jack
mounting on the outside of the drawbar.
--The inner mounting is used for storing the
jack while the machine is in use.
Mount the drawbar.
• Mount the drawbar to the lugs on the front of
the frame with 1-7/16 x 8” long pins and 1/2 x 2”
roll pins found in box 7J857 or 7J858.
• Slide together the upper
and lower brace.
• Install brace, with the lugs up, with the small
tube into the mast on the drawbar and the
large tube into the lugs on the transport axle
rockshaft. Use 1” x 6-1/2” pins and 5/16 x 2”
roll pins.
• Install the ratchet jack to the lugs on the braces
with 1” x 2-1/2” long clevis pins and cotter pins.
Pin, 1-7/16 x 8”
Roll Pins, 1/2 x 2
Pin, 1” x 6-1/2”
Roll Pins 5/16 x 2”
Clevis pins, 1” x 2-1/2”
Cotter pins, 3/16 x 2”
Drawbar
Jack
Figure 9
Ratchet
Handle
Ratchet
Handle Storage