Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 10)

1K705 Page 8
O peration
O peration
The Brillion Soil Builder should be inspected prior
to operation to see that all nuts and bolts are
tight and to be sure that it is in good operating
condition. (After the first few hours of initial
operation, check bolts once again to be sure they
haven’t loosened.)
Hitch the coulter-chisel to the tractor drawbar. It
may be necessary to adjust the adjustable brace
rod assembly of the coulter-chisel so that the
clevis is at the proper height for tractor drawbar.
A 3½ x 16 cylinder is used to raise and lower
the machine. With the cylinder installed, attach
hydraulic hoses to the tractor hydraulic system so
the machine will be lowered when moving control
lever forward.
FIELD OPERATION
To release the transport lock,
extend the transport cylinder
full length and push the lock
handle to the rear to lower
the lock. Lower the machine
to the desired working depth.
If your cylinder is eqipped
with a depth stop, you may
set the depth by adjusting the
moveable hydraulic stop on the
cylinder rod.
IMPORTANT! Remove the handle from the
ratchet jack before raising or lowering the machine
to prevent bending the handle. Store the handle
on the drawbar.
TRANSPORTING THE
COULTER-CHISEL
To transport the unit, extend the
transport cylinder completely
and raise the transport lock into
position by pulling the handle to
the front and latching the handle
in place. Then retract the
cylinder until the weight is taken
up by the lock. The machine is
now ready for transport.
Make sure the ratchet
is stored away from the
machine raising cylinder.
2
1
3
Handle
791rev1-10-08