Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 17)

1K705
ASSEMBLY OF SINGLE WHEEL - (7 & 9 SHANK)
Position the wheel arm assemblies under the
frame as shown in Figures 2a-S and 2b-S. Note
that the wheel hubs and the longer end of wheel
arm pivot tubes are located on the outward side of
the machine.
Take the six bearings (7J627) and coat the inside
bearing surfaces with grease.
Page 15
Wheel Arms
7J627 Bearings
7J627 Bearings
Figure 2a-S
791rev5-30-05
Place one 7J627 bearing on each end of the
wheel arm pivot tube. Position the assembly
under the 10 x 4 frame tube with outside bear-
ing in the outer-most set of holes and the other
bearing lined up with the 3rd set of holes. Bolt
them in place with 3/4-10 NC x 6” capscrews, lock
washers and nuts. (Hardware is in box 7J600 for
7-shank machines and box 1K689 for 9-shank
machines).
Pivot Tube
HHCS, 3/4-10NC x 6”
Lock washers, 3/4”
3/4-10NC Nuts
IMPORTANT!
Coat all bearing surfaces with
grease before installing.
SINGLE WHEEL ASSEMBLY