Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 26)

1K705 Page 24 791rev5-30-05
Figure 8
Place the flat end of the spring rod assembly
between the lugs on the coulter gang. Pin each
spring rod assembly in place with 3/4 x 2-3/4”
clevis pin and cotter pin.
Place the spring rod holder assemblies, with
chamfered plates rearward, onto the front
frame tube centering them over the spring rod
assemblies based on the coulter gangs. Hand
tighten holders to frame with 3/4-10NC U-Bolts,
lock washers and nuts. Figure 8.
Attach the spring rod assembly’s upper end to the
spring rod holder assembly. In this order, place the
following items onto a 3/4-10NC x 1-3/4” screw,
a lock washer, a flat washer and a bushing. Next
insert them through the top hole in the plates on
the spring rod holder assembly turning them into
the tapped holes in the block on top of the spring
rod assembly. Tighten. Figure 8.
Tighten U-Bolts on Spring Rod Holder
Assemblies.
Installation of Spring Rod Assemblies on Coulter Gangs with Spring Rod Holder Assembly
OpExtSoilBuildManualCoulter
Lock Washer,3/4
Bushing
Flat Washer,3/4
HHCS,3/4-10 x 1-3/4
Spring Rod Assy
U-Bolt,3/4-10 x 4
Lock Washer,3/4
Nut,3/4
Lock Washer,3/4
Nut,3/4
5/32 x1-1/2,
Cotter Pin
Clevis Pin
Strap
6C900
Strap
7J597
Strap
7J597
(Center Only)
2-3/4,
Spring Rod Holder