Led warning lights installation, Important – Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame User Manual
Page 39
![background image](/manuals/565209/39/background.png)
Light Bar
Light Bracket
Tube
Light Module
7 Pin
Harness
Lamp
Harness
Red LED Lamp
lens faces rearward
LED Warning Lights Installation
See pages 34, 34A and 34B for part placement
and reference
Attach a Light Bracket Tube to the left front side
of rear frame tube at a distance per page 34A.
Secure with a longer 1/2-13 U-bolt and Flanged
Locknuts.
Route the 7 Pin Harness flat 4 pin plug end
through the Light Bracket Tube's larger cutout
(bottom) to the smaller cutout (top). Mount
Light Bracket Tube on the left front side of
rear frame tube at a distance per page 34A.
Secure with longer 1/2-13 U-bolt and
Flanged Locknuts. Note, 7-Pin Harness
cord should rest on top of the U-bolt.
See Figure on right.
Mount Light Bar, with the light module
opening to the rear right of center, to Light
Bracket Tubes. Secure with smaller 1/2-13
U-bolts and Flanged Locknuts. On the right
side the 7 Pin Harness 4 Pin end should be
below the U-bolt. See Figure on right.
IMPORTANT
Cords are marked Left (Yellow Tape) and
Right (Green Tape).
Layout the Lamp Harness, noting that the
connectors marked with Green Tape is for the
Right Side and Yellow Tape is Left Side. Route
the Lamp Harness through the Light Bar opening
next to where the Light Module is mounted. Run
the 3 pin ends for the red lamps near the center
and the 2 pin ends for the amber lamps at the
end, through the light bar cutout on top of the
tube where the lamps get mounted.
Plug Lamps into Lamp Harness and mount
Lamps to Light bar with 1/4-20 x 1-1/2 Screws
and Locknuts. Red lens must face rearward.
Mount Light Module to Light Bar with 1/4-20 x 3
Screws and Locknuts.
Plug Lamp Harness and 7 Pin Harness into the
Light Module.
Route the 7 Pin Harness along the right frame
center tube towards the front of the machine to
where the two frame halves come together.
Route left to run along the center of the frame to
the left side of the Drawbar. Ensure that the cord
clears all moving parts.
Bundle and secure excess cord to light bar and
frame with Tie Strap
IMPORTANT
All wires must be firmly attached to machine
frame so they do not sag or become torn
loose by field debris.
Attach SMV sign to Light Bar with 5/16-1/8 x 2
Screws, Flat Washers and Locknuts.
Attach plug Holder to Hose Support with 1/4-20 x
3/4 Screws and Locknuts.
NOTE
The plug on the end of the 7 Pin harness
connects to the tractor socket when in use.
When not in use, it can be stored in the Plug
Holder in the hose support bracket. Allow
enough harness length to reach the tractor
socket and secure excess to the drawbar.
OpSoilBuilderElectInstructions
Page 35 1K705