Landoll HSB 71-1 through 131-1 SOIL BUILDER Coulter Chisel - Extended Frame - Manual (Page 24)

1K705
•The arms on the coulter frames should line up
with the 6 pairs of lugs that point rearward
on the spring rockshaft.
Stud
Lock Nut,
5/8-11
Bearing w/
Grease Fitting
Stop Keys
Figure 5
• Place the bearing halves without
grease f ttings on top of the coulter
gang.
• Raise the gang up to get the studs
through the bearings, then put a
bearing half with grease f tting below
the gang tube. Use the thin lock nuts
from box 7J668 for both ends of the
long studs.
Note that on each coulter gang
assembly one of the cast bearings
goes between a pair of keys welded
on the tubing to prevent the coulter
gangs from working sideways.
Page 22 791rev5-30-05