INFICON SKY CDGxxxD (Profibus) - Manual (Page 20)

20
tira54e1-a (2009-01) CDGxxxD.cp
The Block Type ID Parameter contains an ID which describes the block type. The
block type ID of the "Device Block" is set to "1". The other defined block types are
listed in Appendix B.
The Device Type parameter identifies the device type which is connected to the
field bus via Profibus.
The Device Type of the CDGxxxD gauge is "VPG" which is an acronym for
"Vacuum Pressure Gauge".
This parameter describes the version of the "Sensor/Actuator Network Specific
Device Model" published by the SEMI
®
(Semiconductor Equipment and Materials
International, California), according to which the profile of this device has been
developed.
The fixed setting of this parameter is "E54-0997".
This parameter describes the manufacturer of the device. It is set to
"INFICON AG".
This parameter provides the part number of the gauge ( → section "Validity", 3).
This describes the version of the Profibus firmware.
This parameter describes the version of the Profibus adapter hardware.
This parameter provides the serial number of the device.
This parameter provides the current device configuration, e.g. "1000 Torr, 45 C".
This parameter indicates the overall status of the gauge. Due to the structure of the
Device State Machine, the following states are possible:
Parameter value Status
0 Undefined
1 Self testing
2 Idle
3 Self test exception
4 Executing
5 Abort
6 Critical fault
7…50 Reserved by PNO
51…99 Device-specific
100…255 Manufacturer-specific
The device states are described in detail in section "Device Block, Device
Behavior".
7.1 Information on the
individual Indices
7.1.1 Block Type ID (ID 16)
7.1.2 Device Type (ID 17)
7.1.3 Standard Revision Level
(ID 18)
7.1.4 Device Manufacturer
Identifier (ID 19)
7.1.5 Manufacturer Model
Number (ID 20)
7.1.6 Software or Firmware
Revision Level (ID 21)
7.1.7 Hardware Revision Level
(ID 22)
7.1.8 Serial Number (ID 23)
7.1.9 Device Configuration
(ID 24)
7.1.10 Device State (ID 25)