INFICON LDS3000 Modular Leak Detector - Manual (Page 17)

Installation 17
5 Installation
5.1 Rotating the MSB box
If required, you can push the MSB box into the mass spectrometer module LDS3000
on the rear side.
► Remove lock of the MSB box.
► Screw lock into the threads on the rear side of the MSB box.
► Disconnect all cables from the MSB box.
► Disconnect all cable clips from the frame.
► Pull out the MSB box.
► Push MSB box on the rear side and turned (with plug markings upside down) into
the mass spectrometer module LDS3000.
► Connect all cables to the MSB box.
► Fasten all cable clips on the frame.
► Close the lock.
 The mass spectrometer module LDS3000 is ready for operation.
5.2 Installing the mass spectrometer module on the test system
Information The mass spectrometer module can be mounted in any position.
Fig: 4 Components of a fastener
1 Mounting screw M8 x 50
2 Washer
3 MO bearing
4 Test system
5 Nut M8 (self-locking)
6 Base frame
7 Rubber spacer
8 MSB box guide