EZWatch Pro 3.0 User Manual
Page 49
49
when triggered. Click the “Add” to the right to save your settings. Similarly in the lower
part of the window, you can select where you want the camera to go after triggering has stopped.
Once again, click “Add” to save your settings. If you want to remove a setting, simply
highlight the camera and press the corresponding “Delete” button.
• Enable TV out – Enable this function will allow you output video signal to TV. User can
configure which video signal output to TV by customizes his setting.
• Select TV out – User could configure the camera correspondence for TV out function when
alarm is triggered. For detail please refer Chapter 6-19.
• Trigger relays – You can select the specific trigger relays to use and select from Relay 01 to
Relay 03. You also can trigger the relays of each NC-080AZ module. The relay will be
triggered when motion is detected. See details on how to set up the relay output in “The
NetCom system operation menu”.