Despatch Protocol Manager with Protocol 3 and Protocol Plus User Manual

Page 44

Troubleshooting

Protocol Manager Instruction Manual

Version 1

All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

2. Click on

Window

and

Setup

(Figure 35) to get

Comm Setup

(Figure 36).

3. Click on

Network

and highlight the desired oven. Click

Edit

. Make sure addresses on the

Protocol Manager screens match the addresses on each controller (

Figure 37

). For Protocol

Plus controllers, ensure the password is set to the default (Level 2).

Enable Communication

should be enabled. Click

Set

when complete to save changes (if any).

Figure 35. Window Pull Down Menu.

Figure 36. Comm Setup Typical Settings.