Despatch Protocol Manager with Protocol 3 and Protocol Plus - Manual (Page 25)

Protocol Manager Instruction Manual I NSTALLATION & S ETUP
Version 1 25
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
Controller Run Time Window: Collapsed View
Toggle between
full and collapsed views
by double-clicking in the top half of the window
(above Lot Datalogs)
Controller Run Time Window: Expanded View

Operator ID

Lot Information
Set the
Controller Run Time Window parameters by selecting among the check boxes in the
Windows Tab (Section 3.4.4). Note that if the Lot Datalogs box has not been enabled, the
Controller Run Time Window as in Section 3.8 Datalog Functions.
Recipes (profiles) can be started, run and stopped from this window. This window may
be used to remotely control the controller’s operating mode and state. If this window
disappears, click on the
Network Summary window and double-click in the controller
name.
Figure 20. Controller Run Time Window.