Network tab setup – Despatch Protocol Manager with Protocol 3 and Protocol Plus User Manual
Page 19

Protocol Manager Instruction Manual
I
NSTALLATION
&
S
ETUP
Version 1
19
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
controllers. Default
Use Long Timeout Delay
is checked.
e. Press
Accept
to save the parameters.
3.4.3.
Network Tab Setup
Use the Network tab to prepare the Protocol Manager software to communicate with the network
of controllers.
1. Click
Window
(above the User ID) and then
Setup
(Figure 12) to display the Protocol
Manager Setup Window (Figure 15).
2. Click
Network
to begin adding controllers to the system (Figure 15).
3. Add a Protocol 3/Protocol Plus that is controller connected to the host PC:
If the controller will not go online, try a lower Baud Rate.
If the Insert / Edit / Delete buttons are not active (that is,
grayed out), click the space below Name to activate.
Figure 15. Setting Up Network of Controllers.