Dakota Ultrasonics UMX-2 - Manual (Page 8)

4
CHAPTER TWO
QUICK STARTUP GUIDE
The UMX-2 is pre-configured at Dakota Ultrasonics with a specific and common
setup. As a result, the gauge should be ready to measure once the transducer has
been connected. The UMX-2 can use two different styles of transducers; dual
element and single element membrane. As a result, the gauge will be configured
according to the transducer style purchased, as follows:
2.1 Factory Setup Parameters (Single)
UMX-2 Single Element Menu Structure & Factory Configuration
Top Level
STORE DIRECT CLEAR MATL UNITS MODE UMX-2
A 1 NORTH LOC ALU IN E-E-E LT ON
SOUTH STL MM LT OFF
EAST STST LTAUTO
WEST IRON MEMOFF
CIRO UPGRAD
PYC
PLST
PLUR
CUSTOM
2.2 Quick Start (Single Element)
Procedure