Dakota Ultrasonics UMX-2 - Manual (Page 33)

Dakota Ultrasonics
29
in/
µsec
Aluminum 0.2500 6350
Steel (4340 Mild) 0.2330 5918
Stainless Steel (304) 0.2229 5662
Iron 0.2320 5893
Cast Iron 0.1800 4572
PVC 0.0940 2388
Polystyrene 0.0920 2337
Poly Urethane 0.0700 1778
Custom User User
Selecting Material Type
1) Press and hold the single UMX-2 button, located on the top end cap, until
the top level menu options begin scrolling on the alpha display. Once this
occurs, the button can now be released. The menu options will scroll one to
the next in a time delayed sequence, and will display all the menu options in
a continuous loop.
2) When MATL is displayed, immediately press and release the button to enter
the sub menu options. Again, the options will begin scrolling in a continuous
loop.
3) When the material type is displayed, immediately press and release the
button to configure the UMX-2 to the selected material type. For this
example, IRON has been selected.
4) Press and hold the button to escape out of the menu options at any time.