Dakota Ultrasonics UMX-2 - Manual (Page 59)

Dakota Ultrasonics
55
the next in a time delayed sequence, and will display all the menu options in
a continuous loop.
2) When CLEAR is displayed, immediately press and release the button to
enter the sub menu options. CLEAR followed by the current storage
location will alternate (CLEAR…A1…CLEAR…A1).
3) When CLEAR or LOCATION(A1) are being displayed, immediately press
and release the button to clear the current location in the UMX-2. For this
example, A1 has been selected as the storage location.
4) Press and hold the button to escape out of the sub menu options at any
time.
11.9 Downloading the Log File
Once all the measurements have been stored in the log file, the file can be
downloaded to a PC using DakView3 for the purpose of reporting and recordation.
The procedures are outlined in this section.
Note: REFER TO THE SECTION ON CONNECTING TO A PC SECTION
Download Log File
Note: This section assumes the UMX-2 is powered up and ready to go. The
earlier procedure for ‘connecting to a PC’ and ‘Upload Log File’ procedure
should be used for this section, to avoid redundancy. This section outlines only
minor changes to that procedure. The steps have been numbered for easy
insertion.