Atop Technology EH7510 User manual - Manual (Page 55)

Atop Industrial Managed Ethernet Switch
EH7510
User Manual V 1.0
49
2.10.2 Spanning Tree Port
Fig. 2.41 shows how to configure per-port Spanning Tree parameters and indicate each
port ’s status.
Fig. 2.41
*NOTE:
- Recall that Tx Packets are those transmitted/sent out from EH7510, and Rx Packets are
packets received from connected devices, then
- Des Cost: (Designated Root) cost for a packet to travel from a port to the root in the
current Spanning Tree.
- Des Port: (Designated Port) port designated to send the best BPDU.
- Des Root: (Designated Root) device’s priority from which the port must communicate to
reach the Spanning tree’s root.
- Uptime: Indicates how long it has been up.
- Tx/Rx SPT: sending/receiving STP packet total count.
- Tx/Rx TCN: Topology change Notification
- Tx/Rx RSTP: sending/receiving RSTP packet total count.