Atop Technology EH7510 User manual - Manual (Page 101)

Atop Industrial Managed Ethernet Switch
EH7510
User Manual V 1.0
95
3. The Serial Port Setup window pops up. Select appropriate port for Port, 115200
for Baud Rate, 8 bit for Data, none for Parity, and 1 bit for Stop.
Fig. 3.3
4. After finishing settings and clicking OK, a Command Line Interface (CLI) will be
brought up.
3.2 Command Line Interface Introduction
The Command Line Interface supports two types of privileges, which are operator and
manager privileges. Users with operator privileges may only view the information; while
those with manager privileges are allowed to view information and configure settings.
Operator and manager privileges are initially entered without the need of passwords, but a
user may assign password to both the operator and manager. If passwords are assigned,
then when a user attempts to enter the CLI next time, they will need to enter the correct
username and password.
If users enter the password for the operator, then the prompt changes to indicate operator
privilege. Users are now in the “user” mode:
Switch>
If users enter the password for the operator, then the prompt changes to indicate manger
privilege. Users are now in the “privileged” mode:
Switch#
If users are in the user mode and want to switch to the privileged mode, they may simply
type in the command “enable” and then enter the correct username and password following
the prompt:
Switch> enable
Username: (enter username here)