Brady PAM 3000 - Manual (Page 74)

Printer-Applicator-System PAM 3000 C-6
Explanation of the Signals
XDKO - Printhead position - both variations
The signal is necessary to recognize whether the printhead is in its upper or lower position.
XDKO is active if the printhead is in its upper position.
In this state the contact between PIN3 and RÜL (PIN7) is opened.
XDNB - Printer not ready - variation without applicator
An error has occured on the printer.
The label print is stopped and the details and type of error can be read from the printer display
('Ribbon out'; 'Paper out'; 'No label').
After the error is corrected, it is possible to press the key and the print job will be
continued. The last label printed before the error occured will be repeated.
Pressing the key will stop the print job and reset the printer.
XDNB is active if the contact between PIN4 and RÜL (PIN7) is opened.
XDNB - Printer, applicator not ready - variation with applicator
An error has occured on the printer-applicator-system.
The label print and apply is stopped and the details and type of error can be read from the
printer display ('Ribbon out'; 'Paper out'; 'No label').
After the error is corrected, it is possible to press the key and the print job will be
continued. The last label printed before the error occured will be repeated.
Pressing the key will stop the print job and reset the printer.
XDNB is active if the contact between PIN4 and RÜL (PIN7) is opened.
XEPOS - Label is printed - variation without applicator
It is indicated that a label is printed.
XEPOS is active if the contact between PIN5 and RÜL (PIN7) is closed.
XEPOS - Pad in labelling position - variation with applicator
The pad has reached the labelling position.
XEPOS is active if the contact between PIN5 and RÜL (PIN7) is closed.
XESP - Label is dispensed - variation without applicator
It is indicated that the peel-off table is fed back and that way the label is taken.
XESP is active if the contact between PIN6 and RÜL (PIN7) is closed.
XESP - Applying process is ready - variation with applicator
The applying process is completed successfully.
XESP is active if the contact between PIN6 and RÜL (PIN7) is closed.
XEDG - No existing print job - both variations
There is no print job currently available.
In this state the contact between PIN8 and RÜL (PIN7) is opened.
EXF - External error - both variations
An error has occured on the external device.
The label print is stopped and the display of the printer shows the message "External error".
After the error is corrected, it is possible to press the key and the print job will continue.
The last label printed before the error occured will be repeated.