Brady PAM 3000 - Manual (Page 63)

A-5 Printer-Applicator-System PAM 3000
Solution
Check the applicator for proper
operation of its mechanics and
pneumatics; Check the sensor;
Call for Service.
Check the applicator for proper
operation of its mechanics and
pneumatics; Check the sensor;
Call for Service.
Switch printer off
Correct the interface setting in the
printer setup.
Depending on the type of fault, the
command can be skipped by
pressing the
key or the print job
has to be cancelled by pressing the
key.
Check the data on the memory card.
Save the data to another card and
reformat the original card.
Switch printer off and then on
If error recurs ® contact Service
Check the path of transfer ribbon and
media.
Check the printer for proper
operation of its mechanics and
pneumatics;
Call for service;
Format the memory card.
Check the printer for proper
operation of its mechanics and
pneumatics;
Call for service;
Check the printer for proper
operation of its mechanics and
pneumatics;
Call for service;
Format the memory card. Use the
correct type of card as specified in
the Memory card section
Possible cause
Pad has not reached the 0°-position.
Pad has not reached the 90°-position.
The interfaces of computer and printer are
set differently.
Printer has received an unknown or invalid
command (display shows command
abbreviated)
Error when reading from the optional
memory card
Hardware error
The bar code is not correct.
The optional memory card file structure is
not compatible.
The table has not reached its behind
position.
The table has not reached its front position.
The optional memory card is not formatted,
or the type is not supported by the printer.
Error message
Pad 0° error
Pad 90° error
Protocol error (*)
Read error
ROM malfunction
Scan result negative
Structural error
Table not at the back
Table not in front
Unknown card
Table A-3 Error messages (continuation)