Brady PAM 3000 - Manual (Page 50)

Printer-Applicator-System PAM 3000 50
Memory Cards
The printer provides an option for using memory cards to permanently save graphics, fonts,
complete label formats, or database information. Data transfer may be performed via
interface.
It is recommended that you make backup copies in case of malfunction of the original cards.
The printer is able to read from PCMCIA version 2.1 compatible sRAM cards or Flash-
EPROM cards. The maximum memory capacity is 4 MegaByte.
Preparing the Memory Card
1 2 3
Fig. 14b Write protection / Inserting the battery
The write protection of the card may be activated or deactivated by shifting the switch (1)
located at the front side of the card. The interpretation of the setting may be read from an
imprint (3) on the back of the card.
If you want to format the card or write on it, switch off the write protection.
For replacing or inserting the battery in sRAM cards refer to the instructions of the
manufacturer. In case the battery has to be replaced, it is usually found in a slot (2) above the
switch (1).
Installation of the Memory Card
Fig. 14c Installation of the memory card Fig. 14d Connecting side
1 2
3 4
The front side of the memory card (1) is usually marked by the inscription "MEMORY CARD",
and an arrow (2) representing the direction of inserting the card into the drive. There is also
an arrow (4) impressed into the frame of the memory card slot of the printer.
Insert the card (1) into the slot (3) so that the front of the card faces the arrow (4).
At the connecting side of the card there are different guides on the top and the bottom which
make it impossible to insert the card incorrectly.