Brady PAM 3000 - Manual (Page 41)

41 Printer-Applicator-System PAM 3000
xxxx Result of the system test
The four-digit hexadecimal number contains (coded) hardware faults.
The example, as shown in figure 11d, displays "0000" indicating that there have been
no hardware faults.
y Type of peripheral device
2 : Applicator (Default)
3 : None fitted
z Configuration setting Transfer print/ Label sensor
The value of z results from adding the code numbers for selected
settings.
Transfer print : 1 = ON (Default)
0 = OFF
Label sensor : 8 = Bottom-Reflect
4 = Gap sensor (Default)
0 = Top-Reflect
For example, Figure 11d : "5" - Transfer print ON (1) + Gap sensor (4).
C Indicates that the setup configuration has been altered from the defaults
Printer info
5: Windows 1252
Fig. 11 e Printer info display 5
The fifth of the info pages shows the name of the character set as selected in setup.
Delay time
0 ms
Lock time
0 ms
Support del. off
250 ms
Blow time
0 ms
Support delay on
0,0 mm
Fig. 11 f Printer info display 6 - 10
The last five info pages show different settings related to the applicator module.