Brady PAM 3000 - Manual (Page 62)

A-4 Printer-Applicator-System PAM 3000
Error message
Label not depos.
LCD malfunction
Lower position
Memory overflow
No label found *
No label size
No record found
Out of paper *
Out of ribbon *
Solution
Label the product manually
Switch printer off and then on
If error recurs ® contact Service
Check the applicator for proper
operation of its mechanics;
Check the labelling position sensor
(service);
Label the product manually (service)
Check the contents of the card
Press key repeatedly until
printer recognizes the next label on
the material.
Cancel current print job
Change the label format set in the
software; Restart print job
Cancel current print job
Change either software setting or
print media; Restart print job
Check programming
Check programming and/or database
for record in question
Insert new supply roll
Check paper feed
Load new supply roll of transfer
ribbon.
Cancel the current print job.
Change the heat level via software,
clean the printhead, load transfer
ribbon, restart print job.
Cancel current print job
Set software to direct thermal mode
Restart print job
Tighten the supply roll of transfer
ribbon by turning the knurled knob at
the supply hub.
Possible cause
Label has not been placed onto the product;
after cylinder has moved back the label still
sticks on the vacuum plate of the pad
Hardware error
Pad has not reached the labelling position
within 2s after the movement of the cylinder
Current print job contains too much
information (selected fonts, large graphics)
There are labels missing on the label
material
The label format as set in the software does
not correspond with the real label format
Printer is loaded with continuous paper but
the software is set on labels
Definition of the label size is missing at the
label description
No database record has been found
when using optional memory card
Out of label material
Label has not properly been loaded
Out of transfer ribbon
Ribbon melted during printing
The printer is loaded with thermal labels for
direct thermal mode (without transfer ribbon);
but the software is set for transfer printing.
The supply roll of transfer ribbon is turning
on the supply hub.
Table A-3 Error messages (continuation)