Brady PAM 3000 - Manual (Page 27)

27 Printer-Applicator-System PAM 3000
Fig. 6c Power supply module
Connection to Power Supply
1
2
3
4
The PAM 3000 is designed for use with 230V A.C/ 50Hz (standard) or 115V A.C/60Hz.
CAUTION !
Before connecting the printer to the power supply, make sure that the voltage
selected on the power supply module of the printer is the same as your main
power supply !
1 - Voltage selector
2 - Voltage selector cover
3 - Power switch
4 - Power supply connector
To change the voltage setting, open the cover (2) and remove the voltage selector from the
power unit.
CAUTION !
If you have changed the operating voltage of your printer the fuses need replacing
as stated below !
230 V - 2 x T 1.5 A 115 V - 2 x T 3 A
When delivered, the correct fuses for the pre-selected operative voltage are installed. You will
find the necessary fuses for the other voltage in the accessories package.
Slide the voltage selector back into the power supply module so that the correct voltage is
visible in the lid window.
Connect the printer to a grounded outlet using the power cable supplied in the accessories
package.