Brady PAM 3000 - Manual (Page 28)

28 Printer-Applicator-System PAM 3000
Fig. 7a Preparation of the label supply hub
PAM 3000 is equipped with a rotating label supply hub, which is able to take up rolls with a
core diameter of 76 mm.
To take up these label rolls it is necessary to mount two adapters (3) onto the supply hub :
• Put the first adapter (3) onto the supply hub (2) and slide it to the wind plate (4) until it
blocks. Tighten the knurled srew (1).
• Put the second adapter onto the supply hub (2) and slide it against the wind plate until the
distance between the outer edge of the adapter and the wind plate (4) is a little less than
the width of the label roll. Tighten the knurled screw (1).
7 Media Loading
Preparation of the Label Supply Hub
1 2
3
1
3
4