2N Lift8 v1.0 User Manual
Page 75
75
Calling use tone dialling during call – complete list of
commands
During a call it is possible (if automatic dialling with confirmation is used) to use tone
dialling to control
according to the following table. To make them easier to
L8
remember, commands 1 to 5 are arranged in this order, in which they are usually
used.
DTMF
symbol
Description of function
Only if automatic repeat dialling is used. This is a
accor
confirmation
ding to which
knows that the call was successful.
silences a
L8
L8
played announcement and can optionally send an identification code
(DTMF). The call continues after the end of the limit, and one of the
following commands can be used.
Silencing of voice module. NOTA BENE – now after the end of the
software it is no longer necessary for the actual call.
New
of voice module, for 1 repeat of message.
playing
Extension of call The call is extended by the period designated in
parameter 912 (default 120 seconds) after this command if it would
otherwise end earlier. Can be used repeatedly.
or
Termination of call.
This table applies for the mode “voice automatic dialling with confirmation”.
Caution
Using # we can return one level higher in the voice menu.
It is also possible to end a call using #, but only at the highest level of the voice
menu “For connection with the last calling announcer press 0, For connection
with another announcer enter the number of the lift X, For administration,
information, or rescue process press 9, For end of call press #".
Calling to lift which was the last to call Alarm
During entry to voice menu it is possible to call the lift which last called the
Alarm function This is performed by pressing 0.
This function operates only during calling to Lift8 via PSTN, GSM, UMTS.
Note
Option 9 serves for the configuration of the L8– see chapter Configuration.