JLG 1500SJ Service Manual - Manual (Page 534)

SECTION 6 - JLG CONTROL SYSTEM
6-82 – JLG Lift – 3121262
11. Press ENTER. The screen should read as shown
below. When it does, the operator can either press
enter to begin the jib lift sensor calibration, or use
the right or left arrow key to locate the desired jib
sensor calibration. The available sensor calibrations
are:
JIB LIFT
JIB LEVEL
JIB SWING
PLATFORM LEVEL
12. If the operator presses enter at the jib lift sensor cali-
bration prompt, the screen shown below will be dis-
played. At this point, lift the jib up to the mechanical
stop.
13. When the jib is at the mechanical stop, press
ENTER. The screen shown below will be displayed.
At that point, jib lift down until the control system
stops the jib.