Eppendorf BioSpectrometer fluorescence - Manual (Page 41)

41
Methods
Eppendorf BioSpectrometer ® fluorescence
English (EN)
A method procedure is composed of a maximum of 5 steps. The currently active step is highlighted visually.
After the last step,
print & export, of a measuring series, the start of a new measuring series is offered as a
next step. It once again starts with the sample measurement.
Use the [Next >] and [< Back] softkeys to navigate between method steps. With [Abort] and [Finish] you can
cancel or finish the measuring procedure. The name of this softkey changes from [Abort] to [Finish] after
the first sample measurement.
6.5.1 Check parameters
Method step Explanation
Check parameters Check method parameters. Carry out changes if required.
Measure standards Only for methods with standard evaluation:
Measure and evaluate standards. Alternatively, the last saved standard
evaluation can be used.
Measure samples Measuring samples
Process results Only for some methods: postprocess results, e.g. zoom scan graphs.
Print & export Assemble data packets for printing or exporting the data.
Softkeys
• [Page dn] and [Page up]: Change between 1 to 3
parameter list pages.
• [Edit]: Switch to the parameter edit mode.
Editing mode for parameters:
Modified parameters are marked with a red star until
the modification has been saved.
Softkeys
• [Save] and [Save as]: Save changes. When using
[Save as] you have to rename the method. This is
always the case when modifying the methods
preprogrammed by Eppendorf in the Routine
group.
• [Cancel]: Exit the edit mode without saving
changes.