Gateway E-9220T - Manual (Page 79)

74 www.gateway.com
Chapter 6: Troubleshooting
Invalid password
■ Enter your password again. Some passwords are case sensitive.
■ If you do not know the password, you may need to reinstall the software you are
trying to access.
■ System startup passwords are stored in BIOS. If this password has been set and you
do not know it, you may be able to reset the password through system board jumper
settings. For more information, see
“Resetting BIOS passwords” on page 69 .
Memory errors were detected while the system started up
■ See “Memory errors were detected during server start up” on page 82 for a possible
solution.
Memory size error
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2
while your server restarts. Save the memory configuration.
Missing operating system
■ The master boot record may be corrupt. For troubleshooting information, see “The
master boot record is corrupted” on page 81 .
System Event Log Full
■ Clear the event log. To clear or view the event log, restart your server, then open
the BIOS Setup utility by pressing and holding F2 while your server restarts. Select
the
Advanced menu, then select the Event Log Control menu.