Gateway E-9220T - Manual (Page 75)

70 www.gateway.com
Chapter 5: Using the BIOS Setup Utility
3
Remove the jumper across pins 1-2 of header J3F3, then place the jumper across
pins 2-3.
4
Follow the instructions in “Closing the server case” on page 37 .
5
Reconnect the power cords and turn on the server. The BIOS password(s) is cleared.
6
Turn off the server, then disconnect the power cords and all other cables connected
to the server.
7
Follow the instructions in “Opening the server case” on page 30 .
8
Place the jumper back onto pins 1-2.
9
Follow the instructions in “Closing the server case” on page 37 .
Jumper
J3F3