Dial tone detection, Compatibility, Dial tone detection compatibility – Brother IntelliFAX 1360 User Manual
Page 83
Troubleshooting and Routine Maintenance
75
e
Open the Upper Jam Clear Cover (1).
Make sure that there is no jammed
paper left in the corners of the machine.
Note
If the paper is jammed under the print
head, unplug the machine from the power
source, and then move the print head to
take out the paper.
f
Close the Upper Jam Clear Cover.
g
Push the paper tray firmly back into the
machine. While holding the paper tray in
place, pull out the paper support until it
clicks and unfold the paper support (See
the illustrations in Loading
paper on page 9).
Dial Tone detection
B
When you send a fax automatically, by
default your machine will wait for a fixed
amount of time before it starts to dial the
number. By changing the Dial Tone setting to
Detection
you can make your machine dial
as soon as it detects a dial tone. This setting
can save a small amount of time when
sending a fax to many different numbers. If
you change the setting and start having
problems with dialling you should change
back to the default No Detection setting.
a
Press Menu, 0, 5.
b
Press a or b to choose Detection or
No Detection
.
Press OK.
c
Press Stop/Exit.
Compatibility
B
If you are having problems sending or
receiving a fax due to possible interference
on the phone line, we recommend that you
adjust the Equalization for compatibility to
reduce the modem speed for fax operations.
a
Press Menu, 2, 0, 2.
b
Press a or b to choose Basic (or
Normal
).
Basic
cuts the modem speed to
9600 bps. Unless interference is a
recurring problem on your phone
line, you may prefer to use it only
when needed.
Normal
sets the modem speed at
14400 bps. (Default)
Press OK.
c
Press Stop/Exit.
Note
When you change the compatibility to
Basic
, the ECM feature is not available.
1