Brother IntelliFAX 1360 - Manual (Page 28)

20
5
Entering Fax mode
5
To enter fax mode, press (Fax), and
the key will glow green.
The LCD will show the new job number and
the memory available.The number of pages
you can scan into the memory will vary
depending on the data that is printed on them.
Faxing from the ADF
5
a
Make sure you are in Fax mode .
b
Put the document face down in the ADF.
c
Dial the fax number.
d
Press Start.
The machine starts scanning the
document.
Note
• To cancel, press Stop/Exit.
• If the memory is full, the document will be
sent in real time.
Cancelling a fax in progress
5
If you want to cancel a fax while the machine
is scanning, dialling or sending, press
Stop/Exit.
Broadcasting
5
Broadcasting is when the same fax message
is automatically sent to more than one fax
number. You can include Groups (See Setting
up Groups for broadcasting on page 40.),
One-Touch, Speed-Dial numbers, and up to
50 manually dialled numbers in the same
broadcast.
After the broadcast is finished, a Broadcast
Report will be printed.
a
Make sure you are in Fax mode .
b
Load your document.
c
Enter a number. Press OK.
You can use either a One-Touch, a
Speed-Dial, a Group, or a manually
entered number.
d
Repeat c until you have entered all the
fax numbers you wish to broadcast to.
e
Press Start.
Note
• If you did not use up any of the numbers
for Groups, access codes or credit card
numbers, you can ‘broadcast’ faxes to as
many as 160 different numbers.
• The available memory will vary depending
on the types of jobs in the memory and the
number of locations used for
broadcasting. If you broadcast to the
maximum numbers available, you will not
be able to use dual access.
• Enter the long dialling sequence numbers
as you would normally, but remember that
each One-Touch and Speed-Dial number
counts as one number, so the number of
locations you can store becomes limited.
Sending a fax
5