Toshiba Magnia Z300 - Manual (Page 91)

Installing and Removing Hardware
Power Supply Unit
69
Power Supply Unit
Removing the power supply unit
The power supply unit must be removed and attached when
replacing or adding on memory or batteries.
NOTE: The installation and replacement of the power supply
unit requires special technology and knowledge. If you have
no experience in installing the power supply unit or if you
need assistance, consult your authorized MAGNIA service
provider.
Before removing the power supply unit, carefully read “Before
starting operation” on page 48 and proceed as follows:
1 If the server is in operation, first shut it down and switch off the
power supply to it.
2 Unplug the power cable from the AC outlet.
3 Remove the outer covers and server panels from the server.
See “Removing and replacing the server panels” on page 54.
4 Remove six screws, lift up the power supply unit by sliding
forward slightly.
Lifting up the power supply unit.